Reflection 3

FRIDAY,
26th October,2012.

Assalamualaikum and a very good afternoon everyone!!

First of all,,I would like to say "Happy Eidul Adha 2012" to all of the readers out there!!
May Allah save and bless us in every our single steps..;)

Okay,,now I tell you more about what we've done in our previous class during last Tuesday..(23rd October,2012).








TUESDAY,
23rd October,2012.

Today my class start at 10 a.m..while the other class start at 8 a.m..they have a test for Ultiboard. Mine, does not have yet because we did not learn yet about Ultiboard. Just after this we gonna learn about it..and according to my friends,,Ultiboard is more challenger than Multisim. I'm quite nervous knowing that..huhu..@_@..

At 10.15 a.m,,the other class finish their test,,from my observation,,they look happy,,maybe the question given is quite easy thus they can answer it with a broad smile on face..=)

Before start the class,,Mr Redzuan showed us our mark for Multisim test last week. Praised to God,,I got 46.50 out of 50 for the overall mark..^^

Next, Mr Redzuan give us a hand-out paper containing circuit that we will use for Ultiboard. However,,we must draw the circuit using Multisim software first,,and only then we can convert it into Ultiboard. He gave us 15 minutes to draw the circuit into Multisim. Luckily,, I finished it in 15 minutes sharply..haha..

~schematic circuit~

After that,,we must export the circuit into Ultiboard. It's not too difficult at first as we just click 'Transfer' button to make it into Ultiboard and then it will show up all the components that we've drawn. However, be sure that all the components are real components, or else the circuit cannot be convert into Ultiboard. On the left-hand side of the page, there is a toolbox that we use to change the settings of the circuit. For now, Mr Redzuan only asked us to use board outline. Then, he teach us how to change board shape by clicking right-hand side. We can make the shape based on our own creativity.

                                         

Before that,,we must 'off' all the top buttons and only 'on' several buttons so that the circuit can functions well. Okay,,after creating our own design of board, the next step is transferring all the components on the board. Be aware with the overlapping of the wire. It can non-function the board. The process is quite tired because we need to check all the wire connected have no errors and use auto route to modified it. If else, we need to alter it again. Green means the wire is truly connected and red means errors occur. 

                                                 

Lastly, Mr Redzuan showed us how to make the board double-sided,, means that we can change the upper components and placed it below the board,,just click 'Properties' button to change it. 

     

That's all for today's session. Next week, Mr Redzuan will teach us more about Ultiboard since he said that we've a few things that we did not learn yet.

~3D view~

                                   
                                          ~aRigAtou g0zaIma$u~